The MAC-WVC is a wireless valve control system that has been designed as a cost – effective alternative to cabling or cable repairs.

The MAC – WVC can be used for replacing broken cable or tubing where repairs or replacement of damaged cable or tubing
is expensive or not practical.
The system can also be used for new installations where wireless valve control is preferred.
The MAC-WVC system is compatible with most irrigation controllers, excluding 2 wire decoder systems.

MAC – WVC Interface
The MAC – WVC interface board connects to the valve wiring at the controller, and can control up to 8 valves. 3 additional 8
channel expansion boards can be connected allowing up to a total of 32 valves to be controlled wirelessly. The interface board can be
powered using the 240V plug pack, or where mains power is not available, solar/battery power can be used.
The solar powered field node controls a single 2 wire 12VDC latching solenoid via radio communication to the interface board
at the controller.

Broken cable and valve not operating?

• Simply install the 8 channel interface board at the controller.
• Remove the wiring of the broken cable site/s from the irrigation controller and connect to the interface board.
• Install the field node at the valve location, set the unit ID and fit a 12VDC latching solenoid.
• No need to replace the irrigation controller.

The MAC-WVC interface system includes:

• Enclosure
• 8 channel board with radio and system status screen
• Antenna and antenna mount
• 240V plug pack (solar and battery are additional if required)
• Can connect up to 3 8 channel expansion boards for the wireless control of up to 32 valves.